Cropico 3000 SERIES Betriebsanleitung PDF herunterladen (Seite 2)

3000.doc Iss. 2/00

SERIES 3000 THERMOMETER

OPERATING INSTRUCTIONS

SOFTWARE VERSION 6.1

Supplied Accessories

1 Mains Cord

1 Operating Instructions (English)

When unpacked, inspect for physical damage and report any defects immediately in writing, retaining

packaging materials for inspection. Before placing into service, ensure mains voltage is correct.

Instruments are normally supplied for 240Volts 50Hz. Other voltages may also be selected according

to the chart in the Maintenance section. Be sure to also change the fuse to the correct type and rating.

SAFETY

This apparatus is designated Safety class 1 as defined in the IEC publication 1010-1 (Amend 1).

CE MARKING

This apparatus complies with the CE marking directive, 93/68/EEC, and is in compliance with the

following standards:

Generic Emission Standard EN5081-1

Conducted Emissions EN55022 Class B

Radiated Emissions EN55022 Class B

Generic Immunity Standard EN5082-1

Conducted Immunity (Power Lines) prEN60 1000-4-4 1kV

Conducted Immunity (Signal Lines) prEN60 1000-4-4 500V

Radiated Immunity prEN60 1000-4-3 3V/m

Electrostatic Discharge Immunity prEN60 1000-4-2 8kV

Electrical Safety Standard IEC1010-1 (Amend 1)

INSTALLATION

The Series 3000 Thermometers are designed to be either free bench-standing, or for rack-mounting. If

rack-mounting is required, then the mounting kit should be ordered and the instruction supplied with

the kit should be followed. The 3000 series are ½19", 2.5U high.

When connected to a mains supply, the mains cord provided with the equipment should be used, and

connected only to a mains supply with a suitable earth connection. Before connection to the mains

supply ensure that the correct voltage is set, and the fuse is of the correct rating

1 2 3 4 5 6 7 ... 17 18

Keine Kommentare

Cropico 3000 SERIES Betriebsanleitung Seite 2